Selection page when updating your flashpaq new relationship dating tips

Posted by / 10-Mar-2020 14:56

Selection page when updating your flashpaq

Vehicle Preparation Before connecting the FLASHPAQ Tuner to your vehicle, make sure that: • All power-draining accessories are turned off, including radio, lights, cell phones, etc…

The FLASHPAQ Tuner needs full battery voltage to program your vehicle.

To begin, your vehicle’s computer must contain the manufacturer’s STOCK factory program.

If you have used a programmer from another aftermarket company you must use their product to return your computer back to STOCK condition before proceeding.

Consult your performance a to mechanic for the proper vehicle modifications.

Damage caused by towing weights greater than the maximum trailer weight specified for your vehicle shall not be the responsibility of Superchips Inc.

If you have an aftermarket performance-enhancing electronic device installed, it must be removed prior to using the Superchips FLASHPAQ Tuner.

Your Vehicle and Service Centers If you need to return your vehicle to a service center, restore the vehicle’s program to its STOCK program.

We listened to our customers and created this product from your requests.Towing trailer weights above the maximum trailer weight specified by the vehicle manufacturer may cause transmission or other damage.If you wish to tow greater than the maximum trailer weight for your vehicle, modifications to your vehicle may need to be made.This is not covered under your vehicle warranty or Superchips warranty.Your Vehicle’s STOCK Program The FLASHPAQ Tuner stores a copy of your vehicle’s original stock computer program.

selection page when updating your flashpaq-10selection page when updating your flashpaq-35selection page when updating your flashpaq-78

) 5) Press EXIT – returns you to previous screen From the Performance Tuning screen 1) Press ENTER – after selection of Change Setup 2) Press ENTER – after selection of Power Level 3) Press SAVE – after selection of the tuning level Follow ON SCREEN Prompts for octane fuel & option status 1) Press ENTER – after selection of Options 2) Press NEXT/SAVE – adjusts Rev Limiter – You must have Z rated tires to modify the Speed Limiter 3) Press NEXT/SAVE – adjusts Speed Limiter 4) Press SAVE – after adjusting Axle Size 5) Press SAVE – after adjusting Tire height 6) Press SAVE – after adjusting (WOT) shift point 1-2 7) Press SAVE – after adjusting (WOT) shift point 2-3 8) Press SAVE – after adjusting (WOT) shift point 3-4 9) Press SAVE – after adjusting shift pressure 1-2 10) Press SAVE – after adjusting shift pressure 2-3 11) Press SAVE – after adjusting shift pressure 3-4 12) Press EXIT – returns you to previous screen From the Performance Tuning screen 1) Press ENTER – after selection of Program Vehicle 2) Follow ON SCREEN Prompts including Vehicle Ignition ON/OFF requests (DO NOT START VEHICLE!!! Please follow the steps below to return your vehicle to factory stock *** Press DOWN to scroll as needed *** From the Opening screen 1) Press ENTER – after selection of Performance Tuning 2) Press ENTER – after selection of Change Setup 3) Press ENTER – after selection of Power Level 4) Press SAVE – after selecting the Stock tuning level 5) Press EXIT – returns you to previous screen From the Performance Tuning screen 1) Press ENTER – after selection of Program Vehicle 2) Follow ON SCREEN Prompts including Vehicle Ignition ON/OFF requests (DO NOT START VEHICLE!!!

One thought on “selection page when updating your flashpaq”